Sharkbite 24438A Tee Pressure Gauge Assembly Valve 3/4 in

Product Description

The SHARKBITE CASH ACME 24438A is a 3/4 inch brass tee pressure gauge assembly valve designed for monitoring water conditions in potable water and radiant heating systems. This fitting allows a pressure gauge to be installed at a tee point in the line, giving plumbers and hydronic technicians a direct read on system pressure without cutting into the main run permanently. Constructed from brass, the 24438A meets strict certification standards including ASSE 1061, ASSE 1003, NSF/ASME 61, and NSF 372, confirming it is rated for drinking water contact and lead-free compliance.

This valve is suited for residential and light commercial potable water plumbing and radiant floor or panel heating systems. It can be installed as a permanent monitoring point or used temporarily for diagnostic pressure checks, then removed and reused at another location. Licensed plumbers and hydronic system installers are the primary trades who work with this fitting. Its push-to-connect design reduces installation time and eliminates the need for soldering at the gauge port connection.

Key Features

• 3/4 inch tee configuration for inline pressure gauge monitoring
• Brass construction for durability in pressurized water systems
• Reusable design — install permanently or use temporarily for diagnostics
• Rated for potable water and radiant system applications
• ASSE 1061 and ASSE 1003 approved
• NSF/ASME 61 and NSF 372 certified for lead-free, drinking water compliance

Compatibility

Designed for use in 3/4 inch potable water and radiant heating system piping where inline pressure monitoring is required. Compatible with push-to-connect plumbing configurations as noted by ASSE 1061 certification.

Installation Notes

Installation should be performed by a licensed plumber in accordance with applicable local plumbing codes and IPC guidelines. Shut off the water supply and relieve system pressure completely before installing or removing this valve. Ensure pipe ends are clean, deburred, and meet the dimensional requirements for push-to-connect fittings before insertion. When used temporarily, follow the manufacturer removal procedure to avoid damaging the fitting or pipe end for reuse.