Sgs 34527 Square End Mill 0.75in 2 Flute Solid Carbide

Product Description

The SGS 34527 is a solid carbide square end mill designed for high-performance milling in non-ferrous metal applications. With a 0.75 inch cutting diameter, a 3 inch length of cut, and a 45-degree helix angle, this tool delivers aggressive material removal with clean edge geometry. The two-flute spiral configuration provides efficient chip evacuation, reducing heat buildup and maintaining dimensional accuracy through the full depth of cut. It is center-cutting, allowing direct plunge entry without a pre-drilled pilot hole. Machinists and tooling professionals working in CNC milling environments are the primary installers and operators of this tool.

This end mill is intended for milling non-ferrous metals including aluminum, brass, copper, and similar materials where chip flow and tool clearance are critical. The stub length type and 5.25 inch overall length make it well suited for standard vertical and horizontal milling setups where rigidity is a priority. The Weldon flat shank provides positive drive engagement in compatible tool holders, reducing the risk of slippage under load. It fits applications requiring a 0.75 inch shank diameter tool holder.

Key Features

• Solid carbide construction for rigidity and wear resistance in non-ferrous metal cutting
• 45-degree helix angle promotes smooth cutting action and efficient chip evacuation
• Center-cutting design allows plunge milling without a pilot hole
• Weldon flat shank provides secure, anti-slip seating in compatible holders
• Right-hand cut and right-hand flute orientation for standard CNC and manual mill setups
• Two-flute geometry maximizes chip clearance in gummy, high-chip-volume materials

Compatibility

Designed for use with 0.75 inch Weldon flat tool holders on CNC and manual milling machines; primary workpiece material is non-ferrous metal (material code N) per SGS Series 44 specifications.

Installation Notes

Installation and operation should be performed by a qualified machinist or tooling technician familiar with CNC or manual milling equipment. Ensure the spindle is fully stopped and the machine is powered down before inserting or removing the end mill from the tool holder. Verify Weldon flat set screw alignment and recommended torque per the tool holder manufacturer's specifications. Inspect the cutting edges for chips or wear before each use and do not exceed the recommended depth of cut for the workpiece material.