Sgs 31701 Square End Mill 1/16 in 2 Flute Solid Carbide

Product Description

The SGS 31701 is a solid carbide square end mill designed for precision milling in a wide range of materials. Built to Series 17 stub-length standards, it features a 1/16 inch cutting diameter, a 1/8 inch length of cut, and a 1/8 inch straight-cylindrical shank with an overall length of 1.5 inches. The two-flute, right-hand spiral configuration with a 30-degree helix angle promotes efficient chip evacuation and smooth cutting action. Micrograin carbide construction provides the rigidity and edge retention needed for tight-tolerance work. The centercutting geometry allows plunge entry, adding versatility to the tool's application range.

This end mill is suited for light-duty slotting, profiling, and plunging operations on small-feature workpieces. The stub length and small diameter make it well matched for detail work on CNC machining centers and manual mills where minimal overhang and maximum rigidity are required. The uncoated finish and micrograin carbide substrate make it compatible with a broad spectrum of workpiece materials including steel, cast iron, stainless, aluminum, and exotic alloys as indicated by material codes H, K, M, N, P, and S.

Key Features

• 1/16 inch cutting diameter with plus 0.000 / minus 0.002 inch diameter tolerance for consistent sizing
• Solid micrograin carbide construction for edge retention and wear resistance
• 2-flute right-hand spiral with 30-degree helix for efficient chip evacuation
• Centercutting design enables direct plunge entry
• Stub length (Series 17) minimizes overhang and maximizes rigidity in small-feature applications
• Uncoated finish compatible with a wide range of workpiece materials

Compatibility

Compatible with workpiece materials designated under codes H, K, M, N, P, and S, covering hardened steels, cast iron, stainless steels, non-ferrous metals, general steels, and superalloys. Designed as an OEM-style replacement or direct substitute for Series 17 stub-length square end mills with matching geometry.

Installation Notes

Installation should be performed by a qualified machinist familiar with CNC or manual milling operations. Ensure the spindle is fully stopped and the machine is powered down before changing tooling. Use a properly sized collet or end mill holder matching the 1/8 inch shank diameter to avoid runout. Verify tool stick-out is minimized to maintain rigidity, especially at this small diameter.