Senco Fastening Systems A809909 18 Gauge Staples 900ct

Product Description

The SENCO FASTENING SYSTEMS A809909 is an assorted-length pack of 18-gauge galvanized staples designed for narrow-crown pneumatic staplers used in finish carpentry, cabinet assembly, and light construction work. The pack contains 900 staples in lengths ranging from 5/8 inches to 1-1/2 inches, all with a 1/4-inch crown width. The galvanized finish provides corrosion resistance suitable for interior applications where moisture exposure is a factor. These staples are intended for use by carpenters, finish contractors, and general construction tradespeople who require a range of fastener lengths for varied substrate thicknesses in a single package.

This assorted pack fits a wide range of pneumatic and electric narrow-crown staplers and is suited for residential and light commercial applications. Common installation scenarios include cabinet back fastening, drawer assembly, upholstery, soffit installation, underlayment fastening, lattice work, and insulative sheathing attachment. The variety of lengths in a single package reduces the need to stock multiple individual-length boxes when working across different material thicknesses on the same job site.

Key Features

• 900 staples per pack covering lengths from 5/8 inches to 1-1/2 inches
• 18-gauge wire diameter for consistent drive performance in narrow-crown pneumatic staplers
• 1/4-inch crown width for tight, clean fasten points on finish surfaces
• Galvanized finish for corrosion resistance in interior and semi-exposed applications
• Compatible with a broad range of pneumatic and electric staplers from multiple manufacturers
• Suitable for cabinets, case backs, drawers, upholstery, soffits, underlayment, lattice, and insulative sheathing

Compatibility

Fits the following stapler models: Senco LN4450, SKS-L, SLS20, SLS18, SLS15, SKS25XP; Duofast KN1848, KN1848N; Hitachi N3804A; Porter Cable NS100A, NS150A, NSS150; Airy EZ-2; Accuset A150LS, A100LS; Rigid R150FSA; Milwaukee 7155-21; Fasco F25A-90/40; Hilti SN114B; Spotnails HL3852.

Installation Notes

Load staples into compatible pneumatic or electric narrow-crown staplers per the tool manufacturer's loading instructions. Disconnect the air supply or remove the battery before loading or clearing jams. Verify staple length is appropriate for the substrate thickness before driving to avoid blow-through or inadequate penetration. Eye protection should be worn during stapler operation per standard job site safety practices.