Scientific Cutting Tools AND10050-16R Porting Tool Reamer

Product Description

The SCIENTIFIC CUTTING TOOLS AND10050-16R is a precision porting tool reamer designed to machine and finish port faces on hydraulic and pneumatic tube fittings. Built to AND 10050 standards, it produces a 1.965-inch spotface diameter on tube assemblies with a 1-inch outside diameter. The reamer pilot configuration ensures accurate centering and a clean, flat seating surface. With 4 straight flutes and a bright finish, this tool delivers consistent results in metalworking and fluid-power assembly operations. Licensed machinists and fluid-system technicians use this tool when preparing tube-end ports to meet military and aerospace fitting standards.

This porting tool is suited for work on Tube Dash 16 connections in hydraulic, pneumatic, and fluid-power tube assemblies. The AND 10050 standard applies to aerospace and high-performance fluid-system tube fittings, making this tool appropriate for maintenance, repair, and original assembly operations on tube runs requiring precise spotface geometry. The straight-flute design performs well in both hand-held and machine-tool setups where controlled feed rates are maintained.

Key Features

• Spotface diameter of 1.965 inches for Tube Dash 16 fittings per AND 10050 standard
• Reamer-type pilot with a minimum pilot diameter of 1.226 inches and maximum of 1.3385 inches
• Pilot length of 0.825 inches for positive alignment during spotfacing
• 4 straight flutes with bright finish for clean chip evacuation and surface finish
• 1-inch shank diameter with a shank length of 2.25 inches for secure tool holding
• 30-degree seal angle and UN thread type compatibility for standard tube-fitting geometry

Compatibility

Designed for use on tube workpieces with a 1-inch outside diameter conforming to Tube Dash 16 designations under AND 10050 fitting standards.

Installation Notes

This tool is typically used by machinists or fluid-power technicians in a drill press, milling machine, or controlled hand-tool setup. Depressurize and isolate any hydraulic or pneumatic system completely before performing port-face operations on installed tube assemblies. Use appropriate cutting fluid for the workpiece material to protect flute edges and achieve the specified surface finish. Follow applicable aerospace or industrial specifications governing spotface depth and finish requirements for the fitting standard in use.