

Manufacturer pricing rules prevent us from advertising our discount — no account or email required to see it.
Secure Payments
Easy Returns
Expert Advice
Fast Shipping
The RWC U712A is a plastic disconnect clip designed for use with SharkBite push-to-connect fittings. The clip provides a simple, tool-assisted method for releasing the collet on SharkBite fittings, allowing technicians to disengage a fitting from copper, CPVC, or PEX tubing without damaging the fitting or the pipe. It is a single-use accessory that supports clean, controlled disconnection during repairs, modifications, or reconfigurations of push-to-connect plumbing assemblies. Weighing 0.028 pounds, the clip is lightweight and individually bagged for jobsite convenience.
This disconnect clip is sized for 3/4 inch SharkBite push-to-connect fittings and is suited for residential and light commercial plumbing applications. Plumbers and water treatment technicians commonly keep these clips on hand when working with SharkBite systems in supply lines, fixture connections, and water heater installations where fittings may need to be repositioned or replaced.
Designed for use with 3/4 inch SharkBite push-to-connect fittings as a disconnect accessory.
Installation and removal of SharkBite fittings should be performed by a licensed plumber in accordance with local plumbing codes. Before disconnecting any fitting, shut off the water supply and relieve system pressure to prevent uncontrolled water release. Insert the disconnect clip fully around the pipe at the fitting collet before attempting to pull the pipe free. Do not use the clip on fittings that are corroded, visibly damaged, or installed on pressurized lines.
Thanks for subscribing!
This email has been registered!