Rust-oleum 314387 Dtm Acrylic Enamel 1 Gal Black Gloss

Product Description

The RUST-OLEUM 314387 is a fast-drying, water-based direct-to-metal (DTM) acrylic enamel coating in gloss black, available in a 1-gallon container. Formulated as part of the 3800 System, it bonds directly to bare or previously painted metal surfaces without a primer coat, delivering excellent corrosion resistance in mild to moderate exposure environments. The coating lays out evenly when applied by brush or roller with minimal drag, and reaches dry-to-touch in approximately 15 minutes. Licensed applicators, industrial maintenance painters, and facility maintenance crews use this product for both interior and exterior metal surface protection.

This DTM enamel is suited for general industrial and commercial maintenance painting where a durable, corrosion-resistant finish is needed on metal substrates indoors or outdoors. It meets USDA requirements for incidental food contact and is accepted for use in federally registered Canadian food facilities, making it appropriate for food processing or food-adjacent environments. Application is recommended when ambient temperatures are between 50 and 100 degrees F and relative humidity is below 95 percent.

Key Features

• Direct-to-metal formula — no primer required for properly prepared surfaces
• 15-minute dry time reduces downtime during maintenance work
• Excellent corrosion resistance for mild to moderate exposure environments
• Water-based formula for easier cleanup and lower VOC burden
• Meets USDA requirements for incidental food contact
• Two-year rust-proof guarantee for maximum corrosion protection

Compatibility

Designed for direct application to bare metal and previously painted metal surfaces in indoor and outdoor settings. Compatible with standard brush, roller, and spray application methods typical of industrial maintenance coatings.

Installation Notes

Surface preparation is critical — remove loose rust, mill scale, grease, and contaminants before application. Apply only when surface and ambient temperatures are between 50 and 100 degrees F and relative humidity is below 95 percent. Power down or de-energize any equipment being coated before application and allow full cure before returning surfaces to service.