Rust-oleum 245309 Alkyd Enamel Paint Gloss Gray 1280 Fl Oz

Product Description

The RUST-OLEUM 245309 is an alkyd enamel paint formulated for direct-to-metal application in both indoor and outdoor environments. It delivers a gloss finish in a gray color family and ships in a 1,280 fl oz (10-gallon) can. Coverage ranges from 230 to 425 square feet per gallon depending on surface porosity and application method. The VOC content is 340 g/L. Tack-free dry time is 4 hours, full cure is reached at 8 hours, and recoat can occur at 24 hours. Painters, maintenance technicians, and industrial coating contractors typically apply this product where a hard, durable enamel finish is required on metal substrates.

This paint is suited for residential and commercial maintenance applications where a tough, corrosion-resistant finish is needed on metal surfaces. It performs across a wide temperature range, with a minimum application temperature of 32 degrees F and a maximum of 100 degrees F. The direct-to-metal formulation eliminates the need for a separate primer on properly prepared bare metal, making it practical for structural steel, equipment housings, railings, and similar surfaces exposed to both interior and exterior conditions.

Key Features

• Direct-to-metal formulation — no separate primer required on clean, prepared metal
• Gloss finish in gray color family for durable, visible surface protection
• Coverage of 230 to 425 square feet per gallon depending on substrate and application
• Tack-free in 4 hours, fully dry in 8 hours, recoatable at 24 hours
• Rated for indoor and outdoor use across temperatures from 32 to 100 degrees F
• 340 g/L VOC content — verify compliance with local air quality regulations before use

Compatibility

Designed for direct application to bare or previously coated metal surfaces in indoor and outdoor settings. Suitable for use on structural steel, equipment, railings, and similar metal substrates where an alkyd gloss enamel finish is specified.

Installation Notes

Application should be performed by a qualified painter or maintenance technician familiar with surface preparation requirements for alkyd coatings on metal. Clean and degrease all surfaces thoroughly before application — mill scale, rust, oil, and loose coatings must be removed to ensure adhesion. Do not apply below 32 degrees F or above 100 degrees F, and avoid application in high-humidity conditions that can affect dry times. Consult local regulations regarding VOC limits before use, as 340 g/L may restrict use in certain air quality management districts.