Robert Bosch Tool Group DSBS1007 Spade Bit 5/8 Inch 5 Pack

Product Description

The ROBERT BOSCH TOOL GROUP DSBS1007 is a 5/8-inch spade bit designed for fast, clean wood boring in professional trade applications. The full cone threaded tip pulls the bit into the material for effortless entry without pre-drilling. A contoured paddle accelerates chip removal to keep the cut clear, while spur and reamer tips reduce breakout at the exit hole. The hex shank power groove locks into the chuck to minimize slippage during high-torque drilling. Sold in a 5-pack, this bit is suited for electricians, plumbers, and general contractors who need consistent hole quality through framing lumber, studs, and dimensional wood.

The DSBS1007 is used in residential and light commercial rough-in work where clean, fast bored holes are required through wood framing, floor joists, and wall plates. Electricians rely on spade bits like this for running conduit and wire through structural members. Plumbers use them for pipe penetrations in stud bays and floor systems. The 5-pack quantity supports volume work on larger projects where bit wear or loss is a factor on the job site.

Key Features

• Full cone threaded tip pulls into material for fast, effortless entry
• Contoured paddle design promotes rapid chip ejection during drilling
• Spur and reamer tips produce cleaner holes with reduced exit breakout
• Hex shank power groove reduces bit slippage in the chuck under load
• 5/8-inch diameter suits standard rough-in hole sizes for wire and pipe routing
• 5-pack quantity supports high-volume or multi-trade job site use

Compatibility

Designed for use with standard hex-shank compatible drills and impact drivers. Suitable for boring through softwood and hardwood framing typical in residential and light commercial construction.

Installation Notes

Installation is performed by electricians, plumbers, and carpenters using a corded or cordless drill or impact driver with a hex-shank chuck. Ensure the workpiece is secured before drilling to prevent rotation or kickback. When boring through structural members, verify that hole placement complies with applicable building codes regarding notching and boring limits for joists and studs. Wear appropriate eye protection when operating spade bits, as chip ejection is aggressive at higher RPM.