Robert Bosch Tool Group DSB5010 Spade Bit Set 10 Piece

Product Description

The ROBERT BOSCH TOOL GROUP DSB5010 is a 10-piece spade bit set from the Daredevil line, designed for fast, clean boring in wood and wood-based materials. The set features a full cone threaded tip that pulls the bit into the material for effortless entry without pre-drilling. A contoured paddle design accelerates chip removal to keep the hole clear during drilling. Spur and reamer tips produce cleaner hole edges with less tearout. The 1/4-inch hex shank fits standard power drill chucks and quick-change systems. This set covers ten common sizes from 1/4 inch to 1-1/4 inch, making it a practical all-in-one solution for rough-in and finish boring tasks.

This spade bit set is suited for residential and light commercial work where a range of hole sizes is needed in a single kit. Typical applications include boring holes for wire runs, pipe penetrations, and hardware installation in wood framing, joists, studs, and cabinet stock. Electricians, plumbers, and carpenters commonly carry spade bit sets like this for rough-in work where hole quality and speed both matter. The included size range covers most standard conduit knockout, pipe sleeve, and fastener clearance requirements encountered in the field.

Key Features

• Full cone threaded tip pulls the bit into material for fast, low-effort entry
• Contoured paddle design promotes rapid chip ejection and reduced heat buildup
• Spur and reamer tips reduce tearout for cleaner hole edges
• 1/4-inch hex shank is compatible with standard drill chucks and quick-change systems
• 10-piece set covers sizes from 1/4 inch through 1-1/4 inch in a single kit
• 5-inch drilling depth accommodates typical framing lumber and joist thickness

Compatibility

Designed for use with any standard drill or impact driver accepting a 1/4-inch hex shank. Suitable for drilling in wood, plywood, OSB, and similar wood-based materials.

Installation Notes

Spade bits are installed and removed by hand with the tool powered off and the battery disconnected or the cord unplugged. Ensure the hex shank is fully seated in the chuck or quick-change holder before drilling. Do not use spade bits on metal, masonry, or tile. When boring through framing near electrical wiring, follow NEC clearance requirements and use appropriate nail plates where required.