Rivetking. 12N25RC8AP/1100 Aluminum Solid Rivet 0.125 in

Product Description

The RIVETKING. 12N25RC8AP/1100 is a countersunk head solid rivet made from Grade 1100F aluminum with an uncoated finish. The body diameter measures 0.125 inches and the length under the head is 0.25 inches, making it suited for thin-material fastening applications where a flush surface is required. The 78-degree countersunk head angle allows the rivet to seat fully into pre-drilled countersunk holes, leaving a smooth, flush face after installation. This rivet is typically installed by sheet metal workers, HVAC technicians, electricians, and general trade professionals working with aluminum sheet assemblies.

This solid rivet is appropriate for light-duty aluminum joining tasks in residential and light commercial applications. Typical use cases include HVAC ductwork panels, electrical enclosures, light structural sheet metal assemblies, and similar situations where an uncoated aluminum fastener is acceptable. The countersunk profile makes it well suited for any installation where a protruding rivet head would interfere with mating surfaces or finish requirements. It does not meet military specifications and is intended for standard commercial and trade use.

Key Features

• Countersunk head with 78-degree head angle for flush, low-profile installation
• Grade 1100F aluminum construction for lightweight, corrosion-resistant fastening
• 0.125-inch body diameter and 0.25-inch length under head for thin-material applications
• Uncoated finish suitable for standard commercial and trade environments
• Solid rivet design provides a permanent, vibration-resistant mechanical joint

Compatibility

Designed as a standard commercial-grade countersunk solid rivet for use in aluminum sheet metal assemblies and similar light-duty fastening applications where a 0.125-inch body diameter and 0.25-inch grip length are specified.

Installation Notes

Solid rivets require a bucking bar and rivet hammer or a rivet squeezer for proper installation - this is not a blind rivet and cannot be set from one side only. Ensure the receiving material is pre-drilled to the correct hole diameter for a 0.125-inch body before driving. Power down any energized equipment before working in electrical enclosures or control panels. Follow applicable codes and manufacturer guidelines for the host assembly when selecting rivet spacing and edge distance.