Rheem 670007a Clear Pvc Cement 8 Ounce Dwv

Product Description

The RHEEM 670007a is a regular-bodied, clear PVC solvent cement formulated for use on all schedules and classes of PVC pipe and fittings. It is suitable for Schedule 40 pipe up to 4 inches and Schedule 80 pipe up to 2 inches in diameter. This Lo-VOC formula meets California South Coast Air Quality Management District (SCAQMD) 1168/316A, BAAQMD Method 40, and various other environmental regulations. Recommended application temperature ranges from 40 degrees F to 110 degrees F. Plumbers and pipefitters use this cement for potable water systems, pressure pipe, electrical conduit, and drain-waste-vent (DWV) installations.

This cement is well suited for residential and commercial plumbing, irrigation, and electrical conduit applications. On non-pressure DWV systems with pipe under 4 inches, no primer is required where local codes permit, which speeds up the installation process. It is appropriate for use in potable water distribution, sewer lines, and pressure piping systems wherever clear PVC cement is specified by design or code. Licensed plumbers and pipefitters are the primary installers of this product.

Key Features

• Regular-bodied clear formula works on all schedules and classes of PVC pipe and fittings
• Compatible with Schedule 40 pipe up to 4 inches and Schedule 80 pipe up to 2 inches
• Lo-VOC formulation meets SCAQMD 1168/316A and BAAQMD Method 40 environmental standards
• No primer required on non-pressure DWV under 4 inches where local codes allow
• Fast setup time for efficient field installations
• Meets ASTM D-2564 and NSF Standard 61 for potable water, DWV, and sewer applications

Compatibility

Designed for use on all schedules and classes of PVC pipe and fittings: Schedule 40 pipe up to 4 inches and Schedule 80 pipe up to 2 inches. Approved for potable water, pressure pipe, conduit, and DWV systems. IAPMO listed.

Installation Notes

This product is installed by licensed plumbers and pipefitters working under applicable plumbing codes such as the IPC or UPC. Ensure pipe surfaces are clean, dry, and free of burrs before applying cement. Apply cement evenly and join pipe and fittings with a quarter-turn twist, holding firmly until the joint sets. Allow adequate cure time before pressurizing the system, and verify that local codes permit primer-free installation on non-pressure DWV applications before proceeding without primer.