Reed tc3qp Quick Release Tubing Cutter 3/8 to 3-1/2 Inch

Product Description

The REED tc3qp is a quick-release tubing cutter designed for cutting plastic pipe ranging from 3/8 inch to 3-1/2 inch in diameter. It is built for plumbing and mechanical trades that work with ABS, PE, PP, and HDPE piping systems. The cutter features sliding bars constructed with magnesium for added structural strength and durability. It produces clean cuts with minimal burring, reducing post-cut prep time on plastic pipe installations. This tool is intended for licensed plumbers and pipe fitters handling small, medium, and large diameter plastic pipe work in residential and light commercial settings.

The tc3qp is suited for a wide range of plastic pipe applications including drain-waste-vent runs, water service lines, and irrigation systems where ABS, PE, PP, or HDPE pipe is specified. Field use has confirmed it performs well with REED OP2 or 30-40P cutter wheels when cutting ABS pipe. Its quick-release mechanism makes it practical for repetitive cutting tasks across multiple pipe diameters without requiring tool changes, which is useful on busy job sites or in tight access areas.

Key Features

• Cuts plastic pipe from 3/8 inch to 3-1/2 inch diameter
• Quick-release mechanism speeds up repositioning between cuts
• Magnesium-reinforced sliding bars for added strength
• Produces clean cuts with very little burr on plastic pipe
• Compatible with REED OP2 and 30-40P cutter wheels for ABS applications
• Handles small, medium, and large diameter plastic pipe in a single tool

Compatibility

Designed for use on ABS, PE, PP, and HDPE plastic pipe in the 3/8 inch to 3-1/2 inch diameter range. Performs well with REED OP2 or 30-40P cutter wheels when cutting ABS pipe.

Installation Notes

This tool is typically used by licensed plumbers and pipefitters working with plastic pipe systems. Before cutting, secure the pipe to prevent movement and ensure the cutter wheel is properly seated on the pipe surface. Inspect the cutter wheel for wear before use and replace it when cuts become ragged or require excessive force. Follow applicable code requirements under the IPC or local plumbing codes for pipe cut quality and joint preparation standards.