Quiktron 852-442-003 Fiber Optic Patch Cable Sc Sc 10G

Product Description

The QUIKTRON 852-442-003 is a single-mode duplex fiber optic patch cable designed to provide reliable high-speed optical signal transmission in structured cabling installations. This cable features SC connectors on both ends and supports 10 Gigabit data rates, making it well suited for backbone runs, equipment room cross-connects, and patch panel terminations. The PVC jacket provides adequate protection in standard indoor environments. Network technicians and low-voltage installers use this cable to connect fiber-enabled networking hardware within racks, enclosures, and distribution frames.

This patch cable is intended for indoor single-mode fiber optic applications requiring SC-to-SC connectivity at 10G speeds. At 1 meter in length, it is sized for short-reach connections between adjacent equipment such as switches, media converters, transceivers, and patch panels in data closets or equipment rooms. It is sold as a single unit and ships ready to install without field termination.

Key Features

• SC to SC connector configuration for direct equipment-to-panel or equipment-to-equipment runs
• Single-mode fiber construction supports 10 Gigabit transmission speeds
• Duplex configuration carries simultaneous bidirectional optical signals
• 1 meter length suited for short rack-to-rack or panel-to-switch connections
• PVC outer jacket rated for standard indoor installation environments

Compatibility

Designed as a standard single-mode SC duplex patch cable for use with 10G-capable fiber optic switches, transceivers, media converters, and patch panels that accept SC connectors.

Installation Notes

Installation should be performed by a qualified low-voltage or network cabling technician familiar with fiber optic handling procedures. Do not exceed the minimum bend radius of the cable, as sharp bends can cause signal loss or physical damage to the fiber core. Clean SC ferrules with an approved fiber optic cleaning tool before mating connectors to minimize insertion loss. Power down or disable active ports on connected equipment before plugging or unplugging fiber patch cables where possible.