Proto J7010MHT Impact Socket 3/8 in Drive 10mm

Product Description

The PROTO J7010MHT is a 10mm, 6-point impact socket built for 3/8 inch drive impact wrenches and rattle guns used in mechanical, HVAC, plumbing, and electrical trade work. Constructed from alloy steel with a thin-wall profile, this socket delivers reliable torque transfer in tight spaces where a standard-wall socket would not fit. The 6-point contact geometry grips fastener flats squarely, reducing the risk of rounding during high-torque impact applications. At 2 inches overall length, it is suited for general-purpose fastening tasks across a range of service environments.

This socket is a standard addition to a 3/8 inch drive impact set used by HVAC technicians, plumbers, electricians, and general mechanical tradespeople. The thin-wall design is particularly useful when working around flanges, panel edges, or recessed bolt bosses where clearance is limited. It is appropriate for both residential and light commercial service applications where 10mm metric fasteners are common, including equipment mounting, access panel work, and component replacement tasks.

Key Features

• 3/8 inch drive fits standard 3/8 inch drive impact wrenches and ratchets
• 10mm socket size in 6-point configuration for secure fastener engagement
• Thin-wall design improves clearance in recessed or tight fastener locations
• Alloy steel construction rated for impact tool use
• 2 inch overall length suits general-purpose trade service work

Compatibility

Designed as a standard 3/8 inch drive impact socket compatible with 3/8 inch drive impact wrenches, air ratchets, and cordless impact drivers that accept 3/8 inch square drive accessories.

Installation Notes

This socket is installed and used by any licensed trade professional or mechanic working with 3/8 inch drive impact tools. Ensure the socket is fully seated on the drive anvil and the detent pin or retention ring is engaged before applying torque. Do not use impact sockets on manual torque wrenches where calibrated torque values are required unless the tool manufacturer permits it. Inspect the socket for cracks or deformation before each use and remove from service if damage is found.