Proto J1260M Combination Wrench 60 Mm 15 Degree Offset

Product Description

The PROTO J1260M is a heavy-duty combination wrench built for demanding trade and industrial applications. It features a 60 mm head size with a 15-degree offset angle on a straight handle, giving technicians improved knuckle clearance in tight fastener locations. The wrench measures 29-3/4 inches overall length and is constructed from corrosion-resistant steel with a satin finish. At 13.06 pounds, it is sized for large-fastener work on heavy equipment, structural assemblies, and industrial machinery. The 12-point box end configuration provides multiple engagement positions on hex fasteners. This tool meets ASME B107.100-2010 standards and carries a limited lifetime warranty.

This wrench is suited for maintenance technicians, millwrights, pipefitters, and heavy equipment mechanics working on large-diameter fasteners in industrial, construction, and utility environments. The tether-capable design makes it appropriate for elevated work areas and fall-protection programs where tool retention is required by site safety policy. The satin finish reduces glare in reflective work environments and resists surface corrosion during outdoor or wet-condition use.

Key Features

• 60 mm head size for large industrial fasteners
• 15-degree offset angle improves clearance over obstructions
• 12-point box end allows multiple engagement positions
• Tether-capable handle supports fall-protection tool programs
• Corrosion-resistant steel construction with satin finish
• Meets ASME B107.100-2010 standard
• Limited lifetime warranty

Compatibility

Designed for use on 60 mm hex fasteners in industrial, heavy equipment, and structural applications where a large combination wrench with offset head geometry is required.

Installation Notes

This wrench is intended for use by qualified trade professionals and maintenance mechanics. Inspect the wrench for cracks, deformation, or worn contact surfaces before each use and remove from service if damage is found. Do not extend the handle with a pipe or secondary lever, as this exceeds the design load of the tool. When working at elevation, attach the tether point to an approved lanyard per site fall-protection requirements before use.