Pro-source TSL-385-S-YG-PRO Standard Cable Tie 15.2in Green

Product Description

The PRO-SOURCE TSL-385-S-YG-PRO is a standard-duty nylon cable tie designed for bundling and securing wires, hoses, and conduit runs in residential, commercial, and light industrial applications. At 15.2 inches in overall length with a 3/16-inch width and 50 lb tensile strength, this tie handles medium-weight bundling tasks reliably. The green color aids in color-coded organization on job sites or in panel builds. Rated for use from -40 degrees F to 185 degrees F, it performs across a wide thermal range. Electricians, HVAC technicians, and plumbers reach for these during rough-in and finish work wherever wire management or hose bundling is required.

This cable tie suits residential and commercial wiring runs, HVAC low-voltage control wiring, plumbing hose and tubing bundles, and general mechanical assembly. The green color is commonly used as a visual identifier in multi-trade installations or panel wiring to distinguish circuits or systems. With a maximum bundle diameter of 114 millimeters, it accommodates moderate-sized wire harnesses and conduit groups. These ties are sold individually but are available in multiples of 100, making them practical for stocking service vehicles and shop inventory.

Key Features

• 50 lb tensile strength for secure, reliable bundling of wire and hose
• 15.2-inch length accommodates bundles up to 114 mm in diameter
• Green color supports color-coded organization across multi-trade installs
• Nylon construction rated from -40 degrees F to 185 degrees F
• Meets MIL-S 23190E, MIL-SPEC M20693B, UL 94 V-2, and UL Listed standards
• 3/16-inch width provides a low-profile footprint in tight spaces

Compatibility

Designed as a standard nylon cable tie for general-purpose bundling and securing applications in electrical, HVAC, plumbing, and mechanical installations.

Installation Notes

Cable ties are installed by hand or with a cable tie tensioning tool for consistent cinch force and flush tail trimming. Cut the tail flush after tensioning to avoid sharp edges that can damage wire insulation or cause injury. Do not overtension on delicate or thin-wall conduit. Follow applicable NEC or IFGC guidelines when bundling conductors in rated assemblies.