Pro-source TSL-200-S-YS-PRO Standard Cable Tie 8in Gray

Product Description

The PRO-SOURCE TSL-200-S-YS-PRO is a standard-duty nylon cable tie designed for bundling and securing wire harnesses, conduit runs, and general-purpose fastening tasks. At 8 inches in length with a 0.19-inch width and 50 lb tensile strength, it handles moderate-load bundling in both panel work and field installations. The gray nylon construction meets UL 94 V-2 flame rating and is listed to MIL-SPEC standards, making it appropriate for electrical, HVAC, and light industrial applications. Electricians, HVAC technicians, and plumbers commonly use these ties during rough-in and finish work to organize conductors, control wiring, and flexible hose runs.

This cable tie suits residential and light commercial installations where a reliable, heat-rated fastener is needed. The operating temperature range of -40 degrees F to 185 degrees F covers most indoor and protected outdoor environments, including attic spaces, mechanical rooms, and utility enclosures. The maximum bundle diameter of 54 mm accommodates typical wire harness and conduit groupings encountered in standard trade work. Sold individually per package with a minimum order quantity of 100 pieces, these ties are intended for stocking and bulk use on job sites.

Key Features

• 50 lb tensile strength for reliable bundling under load
• 8-inch length with 0.19-inch width accommodates bundles up to 54 mm in diameter
• Nylon construction rated UL 94 V-2 for flame resistance
• Meets MIL-S 23190E, MIL-SPEC M20693B, and UL Listed standards
• Operating range of -40 degrees F to 185 degrees F suits most mechanical and electrical environments
• Gray color for neutral identification in mixed-wire installations

Compatibility

Designed as a standard-duty replacement or stocking cable tie for use in electrical, HVAC, plumbing, and general mechanical installations requiring an 8-inch, 50 lb tensile-strength nylon tie.

Installation Notes

Cable ties are installed by electricians, HVAC technicians, and plumbers as part of wire management and component securing tasks. Always de-energize circuits before working near conductors and follow NEC guidelines for wire bundling and support spacing. Use a cable tie tensioning tool for consistent cinch force and to prevent over-tightening, which can damage insulation. Trim excess tail flush with the locking head after seating to avoid sharp edges in panel enclosures.