Pro-source TSL-200-S-YB-PRO Cable Tie 8in Black Nylon 100pk

Product Description

The PRO-SOURCE TSL-200-S-YB-PRO is a standard-duty nylon cable tie designed for wire bundling, cable management, and general fastening tasks across HVAC, electrical, plumbing, and mechanical installations. Each tie measures 8 inches in overall length with a 0.19-inch width and handles a tensile strength of 50 lb. Made from black nylon, these ties resist UV exposure and perform across a wide temperature range from -40 degrees F to 185 degrees F. This listing covers a pack of 100 ties, making them a practical choice for stocking service vehicles or shop use. Certified to MIL-S 23190E, MIL-SPEC M20693B, and UL Listed standards.

These cable ties suit residential and light commercial applications wherever neat, secure wire routing is required. Electricians use them for panel wiring and conduit runs. HVAC technicians reach for them when dressing low-voltage control wiring, securing refrigerant line insulation, or bundling sensor leads. Plumbers and mechanical contractors use them for organizing tubing and hose assemblies. The 2.12-inch maximum bundle diameter accommodates a wide range of wire harness sizes commonly found in field service work.

Key Features

• 50 lb tensile strength rated for dependable hold under vibration and thermal cycling
• 8-inch length with 2.12-inch maximum bundle diameter for versatile wire management
• Black nylon construction provides UV resistance for indoor and sheltered outdoor use
• Rated from -40 degrees F to 185 degrees F for use in mechanical rooms and rooftop equipment
• Meets MIL-S 23190E, MIL-SPEC M20693B, and UL Listed requirements
• Pack of 100 ties for high-volume field and shop use

Compatibility

Designed as a general-purpose standard cable tie suitable for wire bundling and cable management tasks across electrical, HVAC, plumbing, and mechanical trade applications.

Installation Notes

Cable ties are installed by threading the tail through the locking head and pulling to the desired tension. A flush-cut side cutter or dedicated cable tie tool should be used to trim the tail close to the lock head to prevent sharp edges. Avoid over-tightening on insulated conductors, as excessive tension can compress wire insulation. Follow applicable NEC or project-specific guidelines when bundling electrical conductors.