Pro-source TSL-200-S-MB-PRO Standard Cable Tie 8in Black

Product Description

The PRO-SOURCE TSL-200-S-MB-PRO is a standard-duty nylon cable tie designed for bundling wire harnesses, hoses, and cables in electrical, HVAC, plumbing, and general trade applications. At 8 inches in overall length and 3/16 inch (0.19 inches) wide, this tie delivers 50 lb tensile strength — enough for firm, reliable bundles in most light- to medium-duty service work. Made from black nylon with a UL 94 V-2 flame rating, it meets MIL-SPEC and UL listing requirements. Electricians, HVAC technicians, and plumbers reach for this tie when securing low-voltage wiring, refrigerant line sets, and conduit bundles.

This cable tie suits residential and light commercial service environments. The black nylon construction provides UV resistance, making it appropriate for both indoor and outdoor installations. The rated operating temperature range of -40 degrees F to 185 degrees F covers typical attic, crawlspace, rooftop, and mechanical room conditions. Sold in minimum order quantities of 1000, this tie is stocked for van inventory and job-site use where consistent supply matters. UNSPSC code 39121703 identifies it within standard electrical component classifications.

Key Features

• 50 lb tensile strength for secure wire and hose bundling
• 8 inches overall length accommodates bundles up to 54 mm in diameter
• Black nylon construction with UL 94 V-2 flame rating
• Rated from -40 degrees F to 185 degrees F for demanding install environments
• Meets MIL-S 23190E, MIL-SPEC M20693B, and UL Listed standards
• Bulk packaging in 1000-count minimums for van and job-site stocking

Compatibility

Standard one-piece nylon cable tie compatible with manual and automatic cable tie installation tools accepting 3/16-inch wide, 8-inch length ties. Suitable for wire bundling, conduit strapping, and hose management in electrical, HVAC, plumbing, and pool equipment applications.

Installation Notes

Cable ties should be installed by hand or with a tensioning tool to avoid over-cinching conductors or hoses beyond safe bend radius. Trim the tail flush after tensioning to prevent sharp edges that can cause hand cuts during subsequent service. When used in electrical enclosures, confirm the UL 94 V-2 flame rating is appropriate for the listing requirements of the assembly. Avoid installing in continuous-duty high-heat zones where temperatures exceed 185 degrees F.