Pro-source TSL-150-I-YR-Pro Standard Cable Tie 6in Red 100pk

Product Description

The PRO-SOURCE TSL-150-I-YR-Pro is a standard-duty nylon cable tie designed for bundling wire harnesses, conduit runs, and general fastening tasks in electrical, HVAC, and mechanical installations. At 6 inches in overall length with a 40-pound tensile strength, this tie handles routine bundling loads without slipping or cracking under normal service conditions. The red color aids in color-coded identification of circuits, zones, or service intervals on the job. Rated for continuous use from -40 degrees F to 185 degrees F, it holds up in both outdoor and indoor environments. Each pack contains 100 ties, making it practical for stocking service vans or shop bins.

This cable tie suits residential and light commercial electrical, HVAC control wiring, plumbing support applications, and low-voltage work where quick, reliable bundling is needed. The 0.13-inch width and maximum bundle diameter of 1.49 inches make it well matched for grouping smaller wire runs, thermostat cables, or sensor leads. Electricians, HVAC technicians, and plumbers commonly keep these on hand for panel work, air handler wiring, and equipment service calls. The pack-of-100 format suits high-frequency use in both field and shop settings.

Key Features

• 40-pound tensile strength rated for standard bundling and securing tasks
• 6-inch overall length accommodates bundles up to 1.49 inches in diameter
• Red color supports color-coded wire and circuit identification
• Nylon construction rated from -40 degrees F to 185 degrees F
• Meets MIL-S 23190E, MIL-SPEC M20693B, and UL Listed standards
• Pack of 100 for efficient stocking on service vehicles or at job sites

Compatibility

Designed as a standard one-piece nylon cable tie suitable for general-purpose wire and cable bundling across electrical, HVAC, plumbing, and mechanical applications.

Installation Notes

Cable ties are installed by hand or with a tensioning tool; cut flush any excess tail with diagonal cutters after cinching to avoid sharp edges. Follow NEC or applicable local codes when bundling conductors in panel enclosures or conduit fill applications. Do not exceed the rated tensile strength or maximum bundle diameter to avoid premature failure. Ties installed in direct sunlight or high-UV environments may require UV-rated variants for long-term service.