Pro-source TSL-100-M-YY-Pro Standard Cable Tie 4in Yellow 100pk

Product Description

The PRO-SOURCE TSL-100-M-YY-Pro is a standard-duty nylon cable tie designed for bundling, organizing, and securing wire harnesses, conduit runs, and general-purpose fastening applications. Measuring 4 inches in overall length and 0.1 inches in width, this tie delivers an 18-pound tensile strength — sufficient for light-to-medium wire bundles up to 0.82 inches in diameter. The yellow color aids quick visual identification in panel work or conduit installations. Rated for operation from -40 degrees F to 185 degrees F, these ties hold up in both indoor and outdoor environments. Sold in a pack of 100.

This cable tie is suited for residential and commercial electrical work, HVAC control wiring, low-voltage installations, and panel assembly. Electricians and HVAC technicians use these ties to dress wire bundles inside air handlers, furnace cabinets, electrical panels, and junction boxes. The standard profile fits most manual and automatic cable tie installation tools. Yellow coloring is commonly used to designate specific circuit groups or voltage levels, making these a practical choice where color-coded wire management is required.

Key Features

• 18-pound tensile strength for secure, reliable bundling
• 4-inch length accommodates bundles up to 0.82 inches in diameter
• Nylon construction rated from -40 degrees F to 185 degrees F
• Yellow color supports color-coded wire identification and organization
• Meets MIL-S 23190E, MIL-SPEC M20693B, and UL Listed standards
• Pack of 100 for volume use on installs and service calls

Compatibility

Designed as a standard-profile cable tie compatible with typical manual and automatic tie installation tools used in electrical, HVAC, and low-voltage wiring applications.

Installation Notes

Cable ties are installed by electricians, HVAC technicians, and low-voltage contractors during wiring and panel dress-out. Power down or de-energize circuits before dressing wire bundles inside live equipment enclosures, per NEC guidelines. Use a flush-cut tool to trim the tail cleanly after tensioning to avoid sharp edges that can damage wire insulation. Do not over-tension ties on insulated conductors.