Pro-source TSL-100-M-YG-Pro Standard Cable Tie 4in Green 100pk

Product Description

The PRO-SOURCE TSL-100-M-YG-Pro is a standard-duty nylon cable tie used for bundling wire harnesses, hoses, and cables in electrical, HVAC, plumbing, and general trade applications. Each tie measures 4 inches in overall length and 0.1 inches in width, with an 18-pound tensile strength rated for light-to-medium bundling tasks. The green color aids in color-coded organization on job sites. Sold in packs of 100, these ties are a practical consumable for any service van or panel shop. The nylon construction supports a wide operating temperature range, making them suitable for both indoor mechanical rooms and outdoor utility installations.

These cable ties are appropriate for residential and light commercial applications wherever bundled wire management or temporary securing is required. Typical install scenarios include wire harness routing in air handlers, control panel dressing, low-voltage thermostat wiring, and general service work. The 0.82-inch maximum bundle diameter limits their use to smaller cable groups, so they are best suited for low-voltage wiring runs, sensor leads, and communication cables rather than large conduit bundles. Electricians, HVAC technicians, and plumbers routinely stock these as a shop consumable.

Key Features

• 4-inch overall length with 0.1-inch width for compact, precise bundling
• 18-pound tensile strength suitable for light-to-medium wire management tasks
• Maximum bundle diameter of 0.82 inches for small cable groups and sensor leads
• Green color supports color-coded organization on multi-trade job sites
• Rated from -40 degrees F to 185 degrees F for broad indoor and outdoor service conditions
• MIL-S 23190E, MIL-SPEC M20693B, and UL Listed certifications
• Pack of 100 for efficient restocking of service vehicles and shop inventory

Compatibility

Designed as a standard-style nylon cable tie for general wire bundling and cable management across HVAC, electrical, plumbing, and pool service applications.

Installation Notes

Cable ties are installed by hand or with a cable tie tensioning tool and do not require power-down procedures on their own; however, always de-energize any electrical panel or control board before routing or securing wiring within it. Trim flush with flush-cut pliers after tensioning to eliminate sharp tail ends. Do not over-tension ties on insulated conductors, as crushing can damage wire insulation. Follow NEC guidelines for cable support spacing when using ties as the primary wire management method in electrical installations.