Pro-source PSXK015 Anchor Shackle Screw Pin Alloy

Product Description

The PRO-SOURCE PSXK015 is an alloy anchor shackle with a screw pin closure, designed for load-securing, lifting, and rigging applications. The anchor shackle body provides a wider bow profile compared to a chain shackle, allowing it to accept loads from multiple directions without side-loading the pin. The painted finish provides basic surface protection during storage and handling. At 2.244 pounds, the unit offers substantial material mass consistent with a working-load-rated connector. HVAC, mechanical, and general trade contractors use anchor shackles when rigging equipment during installation or service lifts.

Anchor shackles with screw pin closures are commonly used in overhead lifting, equipment staging, and load-tie-down applications across commercial construction, mechanical contracting, and industrial service work. The screw pin design allows field assembly and disassembly without tools, making it practical for temporary rigging setups. This shackle is suited for applications where the load line may pull at an angle relative to the pin axis, a common condition when lifting HVAC rooftop units or large mechanical equipment.

Key Features

• Anchor-style bow accepts multi-directional loading more reliably than chain-style shackles
• Screw pin closure allows tool-free field assembly and disassembly
• Alloy steel construction provides high strength-to-weight ratio for rigging service
• Painted finish offers surface protection against handling abrasion and short-term storage corrosion
• Compact profile: 4.92 inches length, 4.33 inches width, 1.81 inches height

Compatibility

Designed as a standard screw-pin anchor shackle for general rigging, lifting, and load-securing applications. Verify working load limit and rigging system requirements before installation.

Installation Notes

Screw-pin shackles must be installed by qualified riggers or tradespeople familiar with applicable rigging standards such as ASME B30.26. Always confirm the shackle working load limit against the intended load before use. The screw pin should be fully seated and moused with wire where required by jobsite or code requirements to prevent accidental unscrewing under vibration or cyclic loading. Never side-load the pin or substitute a bolt for the manufacturer-supplied pin.