Pro-source CED6192-8-MSC Warning Cancel Wire Harness

Product Description

The PRO-SOURCE CED6192-8-MSC is a warning cancel wire harness designed to suppress dashboard warning lights triggered by low-current LED bulb installations in automotive and commercial vehicle lighting circuits. When LED bulbs replace standard halogen lamps, onboard systems often detect a load mismatch and generate a fault signal. This harness resolves that condition at the socket level. It is compatible with H11, H8, and H9 base connector styles and operates on both 12-volt and 24-volt systems, making it suitable for passenger vehicles and light commercial applications alike. Installation is handled by automotive electricians or experienced service technicians.

This harness is used when upgrading headlight, fog light, or auxiliary light circuits from halogen to LED bulbs on vehicles equipped with H11, H8, or H9 socket configurations. It is appropriate for both 12V passenger car platforms and 24V light commercial or fleet vehicle applications. The harness plugs directly into the existing factory socket, requiring no cutting or splicing in most standard installations. It measures approximately 22 inches in length, allowing adequate reach in typical headlamp housings.

Key Features

• Cancels load-mismatch warning signals caused by LED bulb upgrades
• Compatible with H11, H8, and H9 base connector styles
• Operates on 12-volt and 24-volt electrical systems
• 22-inch harness length accommodates standard headlamp routing
• Plug-and-play design installs without cutting factory wiring

Compatibility

Designed for use with H11, H8, and H9 socket-based lighting circuits on 12V and 24V vehicle platforms. Consult your vehicle wiring diagram to confirm socket type before installation.

Installation Notes

Disconnect the vehicle battery before servicing any lighting circuit to prevent accidental shorts or airbag deployment. This harness is installed by automotive electricians or qualified service technicians familiar with low-voltage vehicle wiring. Route the harness away from heat sources such as exhaust components and secure all connectors fully before restoring power. Verify connector polarity and socket fit before closing the headlamp housing.