Pro-source 90380200509 Pvc End Cap 2 in Sch 80 Slip

Product Description

The PRO-SOURCE 90380200509 is a 2-inch Schedule 80 PVC end cap with a slip-style end connection. This fitting is used to close off the terminal end of a PVC piping run, creating a sealed dead end in the line. Schedule 80 PVC wall thickness provides greater pressure-handling capability than Schedule 40, making this cap appropriate for systems where elevated working pressures or additional mechanical strength are required. Plumbers and pipefitters install this type of fitting during new construction, system modifications, or when capping unused branch lines. The slip connection means the fitting is solvent-welded onto the outside of a pipe end for a permanent, leak-free joint.

This end cap suits residential and light commercial PVC piping systems, including potable water, irrigation, industrial process, and chemical-handling lines where PVC is chemically compatible with the fluid. It is a standard trade-supply fitting stocked for general plumbing and mechanical contractors who work with 2-inch Schedule 80 PVC pipe. The slip socket design requires standard PVC primer and solvent cement for installation.

Key Features

• Schedule 80 PVC construction for higher pressure ratings compared to Schedule 40
• Slip end connection for solvent-weld installation onto 2-inch PVC pipe
• Closes off open pipe ends in water, irrigation, and compatible industrial systems
• Lightweight at 0.61 pounds, reducing handling fatigue during high-volume installs
• UNSPSC Code 40175300 for procurement and catalog classification

Compatibility

Designed as an OEM-style replacement and standard-service fitting for 2-inch Schedule 80 PVC piping systems using slip-socket solvent-weld connections.

Installation Notes

Installation is performed by a licensed plumber or qualified pipefitter in accordance with applicable IPC or local plumbing codes. Before installing, shut off and depressurize the affected piping system completely. Clean and deburr the pipe end, apply PVC primer to both surfaces, then apply solvent cement and seat the cap with a quarter-turn as specified by the cement manufacturer. Allow full cure time before restoring system pressure.