Pro-source 5150002510JP Air Hose 1/4 in Id 300 Psi Pvc Red

Product Description

The PRO-SOURCE 5150002510JP is a multipurpose PVC air hose sold by the foot from a 500-foot bulk coil, making it a practical choice for shops, service trucks, and job sites that need a specific run length rather than a fixed assembly. The hose measures 0.25 inches inside diameter and 0.47 inches outside diameter, with a 300 psi working pressure rating. Its temperature range runs from 23 degrees F to 150 degrees F, covering most year-round indoor and outdoor service environments. The red PVC construction keeps the hose visible on busy floors and resists common shop fluids. No end connections are included, so fittings are field-installed to match the application.

This hose is suited for general compressed-air distribution in light industrial, automotive, and mechanical service settings. It works well as a supply line between a compressor manifold and a drop point, as a replacement segment in an existing air system, or as raw stock for custom hose assemblies. The cut-to-length format requires a minimum order of 25 feet per cut, with pricing calculated in 1-foot increments. HVAC technicians, plumbers, and general mechanics commonly stock this hose for pneumatic tool supply and blow-down lines.

Key Features

• 300 psi working pressure for standard shop-air and pneumatic-tool service
• 0.25 inch inside diameter provides adequate flow for most 1/4-inch pneumatic circuits
• Operating range of 23 degrees F to 150 degrees F suits year-round use
• Red PVC construction is flexible, lightweight, and easy to spot on the floor
• No end connections included — field-fit with standard 1/4-inch NPT or barb fittings
• Sold by the foot from a 500-foot coil with a 25-foot minimum cut length

Compatibility

Designed as a general-purpose replacement or extension hose for compressed-air systems using 1/4-inch ID hose assemblies. End fittings are not included and must be selected based on the specific pneumatic circuit requirements.

Installation Notes

Installation is typically performed by a qualified mechanic or technician familiar with pneumatic systems. Depressurize and lock out the air supply before cutting or connecting hose sections. Use fittings rated at or above the 300 psi working pressure of the hose, and inspect all barb or compression joints for leaks after pressurizing. Do not exceed the rated working pressure or temperature limits stated on this product.