Precision Brand 81335 Slotted Shim Stock Stainless Steel 10pk

Product Description

The PRECISION BRAND 81335 is a slotted stainless steel shim stock designed for precise mechanical alignment and spacing in industrial and trade applications. Each piece measures 0.5 mm thick, 75 mm wide, and 3 inches long, with a 7/8 inch wide slot that allows the shim to slide around a fastener or shaft without full disassembly. The stainless steel construction resists corrosion and holds dimensional tolerances under load. This package contains 10 individual shim pieces. Machinists, millwrights, and maintenance technicians reach for slotted shim stock when aligning equipment bases, leveling machinery, or setting bearing clearances.

Slotted shim stock of this profile is commonly used in HVAC equipment mounting, pump and motor base alignment, structural leveling, and general mechanical assembly. The 7/8 inch slot width accommodates a range of fastener sizes found in typical equipment mounting configurations. The 75 mm width and 3 inch length suit both compact mounting pads and standard equipment bases encountered in light industrial and commercial service work.

Key Features

• 0.5 mm thickness for fine incremental spacing and alignment
• 7/8 inch wide slot allows installation without full fastener removal
• Stainless steel construction resists corrosion and deformation under compressive load
• 75 mm width and 3 inch length cover a broad range of equipment mounting applications
• Pack of 10 pieces supports multi-point leveling jobs from a single package

Compatibility

Designed as a general-purpose slotted shim stock for use in mechanical alignment, equipment leveling, and precision spacing applications where a 0.5 mm stainless steel shim with a 7/8 inch slot is specified.

Installation Notes

Slotted shim stock is typically installed by licensed millwrights, HVAC technicians, or maintenance mechanics during equipment alignment or leveling procedures. De-energize and lock out all equipment before inserting or adjusting shims under machinery bases or bearing housings. Slide the shim into position via the slot without fully removing mounting fasteners, then snug fasteners gradually and recheck alignment with appropriate measuring tools. Follow applicable equipment manufacturer torque sequences when re-tightening mounting hardware after shimming.