Precision Brand 35605 Partial Stainless Worm Gear Hose Clamp

Product Description

The PRECISION BRAND 35605 is a partial stainless worm gear hose clamp designed for secure, corrosion-resistant clamping in demanding trade applications. Built with a three-piece construction and no spot welds, it eliminates a common failure point found in lower-grade clamps. Rounded edges protect the hose surface from cutting or abrasion during installation and under operating pressure. This clamp covers a clamping range of 5 inches to 7 inches and meets or exceeds SAE torque specifications, making it appropriate for installations where torque compliance is required.

This clamp is suited for use in plumbing, HVAC, and general mechanical applications where a reliable hose-to-fitting connection is needed. The partial stainless construction offers corrosion resistance in moderate to high-moisture environments. It is commonly installed by plumbers, HVAC technicians, and mechanical contractors working on water lines, coolant lines, and duct connections. The clamp is sold in packs with a minimum order quantity of 10 units, making it practical for service vehicles and job-site stock.

Key Features

• Three-piece construction with no spot welds eliminates weld corrosion and stress fractures
• Rounded edges protect hose material from cutting or abrasion during and after installation
• Partial stainless build provides corrosion resistance in wet or humid environments
• Meets or exceeds SAE torque specifications for compliant installations
• Clamping range of 5 inches to 7 inches suits a wide variety of hose and fitting sizes

Compatibility

Designed as a worm gear hose clamp for use on hoses with outside diameters in the 5-inch to 7-inch range, suitable for typical plumbing, HVAC, and mechanical piping applications.

Installation Notes

Installation is typically performed by licensed plumbers, HVAC technicians, or mechanical contractors using a standard flathead or hex-drive screwdriver and a torque tool where SAE compliance is required. Shut off fluid flow and depressurize the line before removing or installing any hose clamp. Position the clamp evenly over the hose-to-fitting interface and tighten to the SAE-specified torque range without over-torquing, which can damage the hose. Inspect the clamp for proper seating before returning the system to service.

Technical Specifications

• Clamping Range: 5 inches to 7 inches
• Construction: Partial stainless, three-piece, no spot welds
• Torque Standard: Meets or exceeds SAE specifications
• Weight: 0.12 pounds
• Unit of Measure: Pack
• Minimum Order Quantity: 10

Standard Information

• Brand: PRECISION BRAND
• Manufacturer Part Number: 35605