Precision Brand 35185 Worm Gear Hose Clamp 9/16 to 1-1/16 in

Product Description

The PRECISION BRAND 35185 is a partial stainless worm gear hose clamp engineered for demanding installation environments across plumbing, HVAC, and general mechanical applications. Its three-piece construction eliminates spot welds, removing a common failure point that leads to corrosion over time. Rounded edges protect the hose from cuts and abrasion during tightening. The clamp meets or exceeds SAE torque specifications, making it suitable for professional installations where torque compliance is required. Licensed plumbers, HVAC technicians, and mechanical contractors routinely use worm gear clamps of this type to secure hose connections in fluid and air handling systems.

The 35185 fits hose outer diameters ranging from 9/16 inches to 1-1/16 inches, covering a range of small-diameter hoses common in residential and light commercial systems. It is sold in packs, with a minimum order quantity of 10 units, making it practical for service vehicles and shop stock. Typical applications include coolant hose connections, condensate drain lines, and flexible pipe fittings where a secure, corrosion-resistant band clamp is required.

Key Features

• Partial stainless construction resists corrosion in wet and humid environments
• Three-piece design with no spot welds eliminates a common corrosion and fatigue failure point
• Rounded edges prevent hose abrasion and cutting during installation and service
• Meets or exceeds SAE torque specifications for professional compliance
• Clamp range of 9/16 inches to 1-1/16 inches suits small-diameter hose connections
• Sold in packs of 10 for efficient stocking and jobsite use

Compatibility

Designed as a standard worm gear hose clamp replacement suitable for small-diameter hose connections in plumbing, HVAC condensate, and general mechanical applications where the hose outer diameter falls between 9/16 inches and 1-1/16 inches.

Installation Notes

Plumbers, HVAC technicians, and mechanical contractors typically install worm gear hose clamps using a flat-head or hex-drive screwdriver and torque driver. Always depressurize and isolate the line before removing or installing a hose clamp. Position the clamp band so the screw housing does not obstruct access to adjacent fittings. Tighten to the torque level specified by the hose or fitting manufacturer and in accordance with applicable SAE guidelines.

Technical Specifications

• Clamp Range: 9/16 inches to 1-1/16 inches
• Construction Type: Partial stainless worm gear, three-piece
• Weight: 0.04 pounds
• Minimum Order Quantity: 10 units per pack
• Torque Compliance: Meets or exceeds SAE specifications

Standard Information

• Brand: PRECISION BRAND
• Manufacturer Part Number: 35185