Pps 95530 45 Degree Elbow 2-1/2 Inch 304 Ss Megapress

Product Description

The PPS 95530 is a 2-1/2 inch 45-degree elbow fitting manufactured in 304 stainless steel, designed for use with the Viega MegaPress press-fit connection system. This fitting allows a direction change of 45 degrees in a piping run without threading, soldering, or welding. The press-fit design speeds up installation and eliminates open-flame work, making it well suited for mechanical rooms and close-quarter pipe runs. Stainless steel construction provides corrosion resistance in demanding service conditions. Licensed plumbers and pipefitters are the primary installers for this type of fitting in commercial and industrial piping systems.

This elbow is intended for use in piping systems where the Viega MegaPress press-fit platform is already specified or installed. It is appropriate for commercial and light industrial applications including HVAC hydronic systems, domestic water distribution, and mechanical piping where 304 stainless steel is required for corrosion resistance or code compliance. The 2-1/2 inch size is commonly found in larger commercial piping headers and branch lines.

Key Features

• 45-degree elbow geometry for moderate directional changes in pipe routing
• 304 stainless steel construction for corrosion resistance in commercial service
• Press-fit connection compatible with the Viega MegaPress tool system
• 2-1/2 inch size suitable for larger commercial and mechanical piping runs
• No open flame required — eliminates solder and weld connection steps

Compatibility

Designed as an OEM-style press-fit fitting for use within the Viega MegaPress stainless steel press-fit piping system in 2-1/2 inch diameter pipe configurations.

Installation Notes

Installation of press-fit stainless steel fittings should be performed by a licensed plumber or pipefitter in accordance with applicable local plumbing codes and the fitting manufacturer's tool and procedure requirements. Shut off and depressurize the piping system completely before cutting into the line or inserting fittings. Use only the press jaw and tool specified for the MegaPress system on this pipe size — using an incorrect jaw size or tool can result in an improper seal. Verify pipe ends are cut square, deburred, and marked to the correct insertion depth before pressing.