Plumb Shop Div Brasscraft 823-583 Lavatory S Trap 1-1/4 in

Product Description

The PLUMB SHOP DIV BRASSCRAFT 823-583 is a white plastic S trap designed for lavatory and floor drain applications. It connects 1-1/4 inch outer diameter tubing on both ends using slip joint fittings, and includes the nuts and washers needed for assembly. This trap maintains the water seal required by code to block sewer gases from entering occupied spaces. Plumbers and drain installers use this part in residential bathroom sink and lavatory drain rough-in work where a compact S trap configuration is required. The plastic construction resists corrosion and keeps weight low during installation.

This S trap is suited for residential lavatory drain installations where the drain outlet routes through the floor rather than the wall. It fits standard 1-1/4 inch OD plastic drain tubing and works with slip joint connections, making it straightforward to fit into existing or new lavatory drain assemblies. The included hardware means no separate trip to the supply house for nuts and washers. Typical installs include vanity sinks, pedestal lavs, and similar residential fixtures draining to a below-floor waste line.

Key Features

• 1-1/4 inch OD tube slip joint connections on both inlet and outlet
• White plastic construction resists corrosion and chemical attack from drain waste
• S trap geometry directs drain flow through the floor for under-floor waste line hookups
• Includes nuts and washers — no separate hardware required for slip joint assembly
• Lightweight at 0.6 pounds, reducing handling effort in tight vanity cabinet spaces

Compatibility

Designed as an OEM-style replacement or new-installation S trap for residential lavatory drain assemblies using 1-1/4 inch OD plastic drain tubing with slip joint connections.

Installation Notes

A licensed plumber should verify local code acceptance of S trap configurations before installation, as some jurisdictions restrict or prohibit S traps in favor of P traps vented to an air admittance valve or wet vent system. Shut off the water supply and clear the work area under the vanity before beginning drain assembly. Hand-tighten slip joint nuts first, then snug with slip joint pliers — avoid over-tightening plastic fittings. After installation, run water and inspect all joints for leaks before closing up the cabinet.