Pip 19-D340OR/S Cut Resistant Gloves Small Ansi A4

Product Description

The PIP 19-D340OR/S is a cut, puncture, and abrasion-resistant work glove designed for trade and industrial professionals who require reliable hand protection without sacrificing dexterity. Built on a 13-gauge seamless Dyneema Diamond shell, the glove achieves an ANSI/ISEA Cut Resistance Level A4 and an ANSI/ISEA Puncture Resistance Level 4, making it suitable for demanding jobsite tasks. The palm and fingers are coated with foam nitrile, which provides a breathable grip surface while maintaining durability across a wide range of materials handling, mechanical, and construction applications. The glove is sold as a pair and weighs approximately 0.19 pounds.

This glove fits workers in HVAC, plumbing, electrical, construction, and general mechanical trades where sharp edges, wire, sheet metal, conduit, or abrasive surfaces present hand injury risk. The high-visibility orange colorway improves hand visibility during work near energized equipment or active job zones. The seamless knit construction reduces pressure points during extended wear, and the foam nitrile coating delivers tactile sensitivity needed for precision tasks such as fitting assembly or wire routing. The glove is rated for unisex use in a Small size, which corresponds to a Women's X-Small.

Key Features

• ANSI/ISEA Cut Resistance Level A4 and Puncture Resistance Level 4 for multi-hazard hand protection
• ANSI/ISEA Abrasion Resistance Level 4 and EN 388 Rating 4544DX
• 13-gauge seamless Dyneema Diamond shell for lightweight dexterity and tactile sensitivity
• Foam nitrile palm and finger coating for breathable, durable grip on dry and light wet surfaces
• High-visibility orange shell with black nitrile coating for improved hand visibility on site
• Seamless knit construction reduces irritation during extended use

Compatibility

Designed as an OEM-style replacement and standard-issue protective glove for trade professionals requiring ANSI Cut A4 hand protection in mechanical, electrical, HVAC, and general construction environments.

Installation Notes

Inspect gloves before each use for coating separation, cuts through the shell, or visible wear that would compromise cut resistance. Replace any glove that shows through-shell damage, as a compromised shell no longer meets rated protection levels. Glove selection should conform to applicable OSHA 29 CFR 1910.138 personal protective equipment requirements for hand hazards on the jobsite.