Pip 19-D334/L Cut Resistant Gloves Size L Ansi A3

Product Description

The PIP 19-D334/L is a cut, puncture, and abrasion-resistant work glove engineered for trade professionals who need reliable hand protection without sacrificing dexterity. Built on a 13-gauge Dyneema Diamond blended shell with a seamless knit construction, this glove delivers ANSI/ISEA Cut Level A3 and Puncture Level 3 performance. The palm and fingers are coated with foam nitrile for a secure grip on dry and lightly oily surfaces. At 9.8 inches overall length, the glove provides coverage from fingertip through a knit cuff. It is rated ANSI Abrasion Level 4 and carries an EN 388 rating of 4443C, making it a solid choice for demanding jobsite conditions.

This glove is suited for light industrial, electrical, plumbing, HVAC, and general trade applications where cut and puncture hazards are present alongside the need for tactile sensitivity. The foam nitrile palm coating supports grip on tools, conduit, fittings, and pipe. The seamless Dyneema Diamond lining reduces interior irritation during extended wear. The unisex sizing fits a Large mens hand or Medium womens hand, making it practical for mixed crews. The salt and pepper colorway is a standard glove appearance for general trade environments.

Key Features

• ANSI/ISEA Cut Resistance Level A3 and Puncture Resistance Level 3 for multi-hazard hand protection
• 13-gauge Dyneema Diamond blended shell provides lightweight cut resistance with strong tactile sensitivity
• Foam nitrile dipped coating covers palm and fingers for grip on tools and fittings
• ANSI Abrasion Level 4 and EN 388 rating 4443C for verified abrasion durability
• Seamless knit construction reduces interior seam pressure during extended wear
• Knit cuff with 3-inch cuff length holds glove in place during active work

Compatibility

Designed as a general-purpose cut and puncture-resistant glove for trade professionals; suitable for use in HVAC, plumbing, electrical, and light industrial applications where ANSI Cut Level A3 protection is required.

Installation Notes

Inspect gloves before each use for tears, coating separation, or visible damage to the shell. Power down electrical systems and shut off gas or water supply before beginning work where hand protection is required by jobsite safety protocols. Replace gloves if the nitrile coating shows cracking or delamination, as reduced coating integrity affects grip and protection. Glove selection should be verified against site-specific hazard assessments and applicable OSHA hand protection requirements.