Pip 19-D326/S Cut Resistant Gloves Ansi A3 Small

Product Description

The PIP 19-D326/S is a cut, puncture, and abrasion-resistant work glove designed for trade and industrial applications where hand protection and dexterity must coexist. Built on a 13-gauge seamless Dyneema Diamond and Spandex shell, it carries an ANSI/ISEA Cut Resistance Level A3, Puncture Resistance Level 2, and Abrasion Resistance Level 4, along with an EN 388 rating of 4442CX. The palm and fingers are dipped in polyurethane for a flat grip surface that maintains tactile sensitivity on precision tasks. At 9.1 inches overall length, this glove fits a Small hand size and is sold as a paired set. Licensed HVAC technicians, electricians, plumbers, and general industrial workers handling sheet metal, conduit, and sharp components are the primary installers and users.

This glove is suited for light-to-medium-duty applications where cut and puncture hazards are present but full-hand encapsulation is not required. The polyurethane palm and finger coating performs well in dry to slightly oily conditions. The seamless knit construction reduces interior seam irritation during extended wear, and the knit cuff with black finish provides a secure, comfortable wrist fit. Its lightweight Dyneema Diamond lining offers cut resistance without sacrificing the hand movement needed for detailed work such as wire pulling, fitting assembly, or panel work.

Key Features

• ANSI/ISEA Cut Resistance Level A3 with EN 388 rating of 4442CX
• ANSI/ISEA Puncture Resistance Level 2 for protection against sharp protrusions
• ANSI/ISEA Abrasion Resistance Level 4 for durability on rough surfaces
• 13-gauge seamless Dyneema Diamond and Spandex shell for lightweight dexterity
• Polyurethane dip coating on palm and fingers provides flat grip and tactile sensitivity
• Seamless construction reduces pressure points and increases breathability during extended wear

Compatibility

Designed as an OEM-style replacement or direct procurement glove for Small-sized hand protection programs requiring ANSI A3 cut resistance with polyurethane palm coating.

Installation Notes

Inspect gloves before each use for tears, punctures, or coating separation that would compromise protection. Gloves should be replaced when coating shows visible cracking, peeling, or loss of grip surface integrity. Follow your facility or jobsite PPE program guidelines for glove selection, use, and disposal. Do not use these gloves as a substitute for arc flash, chemical splash, or electrical insulation protection.