Pip 19-D322/XXL Cut Resistant Gloves 2XL Ansi A4

Product Description

The PIP 19-D322/XXL is a cut, puncture, and abrasion-resistant glove engineered for trade and industrial professionals who work with sharp materials, sheet metal, glass, or abrasive surfaces. Built on a 13-gauge Dyneema Diamond fiber shell, the glove achieves an ANSI/ISEA Cut Resistance Level of A4 and an ANSI/ISEA Puncture Resistance Level of 3, with an ANSI Abrasion Resistance Level of 4. A gray polyurethane dip coating covers the palm and fingers, delivering a flat grip surface that maintains dexterity for part handling and assembly tasks. The seamless knit lining and HPPE stitching contribute to all-day wear comfort. Overall length is 10.5 inches with a 3-inch knit cuff.

This glove is suited for residential and light commercial applications where hand protection is required without sacrificing tactile sensitivity. Typical install scenarios include HVAC sheet metal work, electrical conduit handling, plumbing rough-in, and general mechanical assembly. The unisex sizing fits a men's 2X-Large or women's 3X-Large hand. The pair format means both hands are covered from a single package unit. The EN 388 rating of 4X42DX confirms performance validation under European abrasion, cut, tear, and puncture standards as well.

Key Features

• ANSI/ISEA Cut Resistance Level A4 for protection against sharp edges and sheet metal
• ANSI/ISEA Puncture Resistance Level 3 for resistance to nail, wire, and staple hazards
• ANSI/ISEA Abrasion Resistance Level 4 for durability against rough surfaces
• 13-gauge Dyneema Diamond fiber shell with seamless knit lining for dexterity and comfort
• Gray polyurethane palm and finger coating with flat grip surface for dry part handling
• EN 388 rated 4X42DX for internationally recognized cut and abrasion performance

Compatibility

Designed as an OEM-style hand protection solution for trade professionals requiring ANSI A4 cut resistance in a lightweight knit glove format. Part of the PIP Series 19-D322 product line.

Installation Notes

Inspect gloves before each use for tears, coating separation, or worn areas that could compromise protection. These gloves are intended for dry handling conditions; the polyurethane coating is not rated for wet or oily environments. Replace immediately if structural damage is found. Proper glove selection and fit should comply with applicable OSHA 29 CFR 1910.138 personal protective equipment requirements.