Pip 19-D322/XS Cut Resistant Gloves Xs Ansi A4 Dyneema

Product Description

The PIP 19-D322/XS is a cut, puncture, and abrasion-resistant work glove engineered for trade professionals who handle sharp materials, sheet metal, glass, or other hazardous surfaces. Built on a 13-gauge Dyneema Diamond fiber shell, these gloves achieve ANSI/ISEA Cut Level A4, Puncture Level 3, and Abrasion Level 4 ratings. The palm and fingers are dipped in gray polyurethane, providing a smooth, tactile grip surface without sacrificing dexterity. At 8.5 inches overall length with a 3-inch knit cuff, the XS size fits most smaller hands in a seamless-lined, unisex design. HVAC technicians, electricians, plumbers, and general contractors use these as an everyday cut-protection glove during parts handling and rough material work.

These gloves are suited for residential and commercial trade applications where cut and puncture hazards are present alongside the need for finger dexterity. Typical use cases include sheet metal handling during HVAC duct fabrication, conduit work, pipe fitting, and general mechanical assembly. The knit cuff and seamless Dyneema lining keep comfort high during extended wear. Rated to EN 388 standard with a published rating of 4X42DX, making them appropriate for job sites that require documented hand-protection compliance.

Key Features

• ANSI/ISEA Cut Resistance Level A4 for protection against sharp edges and sheet metal
• ANSI/ISEA Puncture Resistance Level 3 for protection against nail, wire, and fastener hazards
• ANSI/ISEA Abrasion Resistance Level 4 for durability against rough surfaces
• 13-gauge Dyneema Diamond fiber shell with seamless knit lining for dexterity and comfort
• Gray polyurethane dip coating on palm and fingers provides tactile grip control
• EN 388 rated (4X42DX) to support job site PPE documentation requirements

Compatibility

Designed as an OEM-style cut and puncture protection glove for trade professionals requiring ANSI/ISEA A4 cut resistance in an XS hand size.

Installation Notes

PPE gloves of this type are selected and fitted by the end user or safety supervisor per applicable OSHA hand protection requirements (29 CFR 1910.138). Inspect gloves before each use for tears, coating separation, or material degradation that may reduce protection levels. Gloves should be replaced when physical damage or wear is observed. Do not use these gloves as a substitute for arc flash, chemical, or electrical insulating protection.