Pentair 6500XL 6-roller Spray Pump 22 Gpm 300 Psi

Product Description

The PENTAIR 6500XL is a 6-roller spray pump designed for medium-pressure liquid transfer and spray applications. Built with a SilverCast housing, this pump delivers up to 22 GPM at a maximum working pressure of 300 psi and a maximum speed of 1200 RPM. The roller assembly uses PTFE rollers, and the shaft is machined from 416 stainless steel for corrosion resistance in demanding service environments. A Viton lip seal provides reliable fluid containment against a wide range of chemicals and solvents. This is a pump-only unit, requiring a compatible drive source. Licensed plumbing and irrigation contractors as well as agricultural and spray equipment technicians are the typical installers.

The 6500XL fits residential and light commercial spray, chemical transfer, and liquid handling systems where a compact, high-pressure roller pump is required. The 3/4 inch FPT inlet and 3/4 inch FPT outlet use NPT threading, making integration into standard plumbing manifolds and spray rigs straightforward. The unit weighs 9 pounds, making it manageable for field installations and equipment skid mounting.

Key Features

• 6-roller design for consistent flow at pressures up to 300 psi
• SilverCast housing material for durability in spray and transfer service
• PTFE roller material for compatibility with a broad range of process fluids
• Viton lip seal for chemical resistance and long service life
• 416 stainless steel shaft resists corrosion in wet environments
• 3/4 inch FPT x FPT NPT connections for standard plumbing integration
• Maximum flow rate of 22 GPM at up to 1200 RPM

Compatibility

Designed as an OEM-style replacement or direct-fit pump for systems requiring a 6-roller spray pump with 3/4 inch NPT FPT inlet and outlet connections and a 300 psi maximum working pressure rating.

Installation Notes

Installation should be performed by a qualified technician familiar with pressurized fluid systems and applicable plumbing codes. Depressurize and drain the system fully before removing the existing pump or making any connections. Verify that the drive source RPM does not exceed the 1200 RPM maximum to avoid seal and roller damage. Ensure all NPT threaded connections are properly sealed with an approved thread sealant rated for the process fluid in use.