Pass Seymour TP8LACP10 Duplex Wall Plate 1 Gang 10 Pack

Product Description

The PASS SEYMOUR TP8LACP10 is a 1-gang nylon wall plate designed to cover a single duplex outlet opening. Sold in a 10-pack in a light almond finish, it is molded from self-extinguishing nylon for durability and compliance with fire-safety standards. The plate measures 2.9375 inches by 4.6875 inches, which is 3/16 inches taller and wider than a standard-size wall plate, providing better coverage over cutouts and surface imperfections. Electricians and maintenance technicians install these during rough-in finish work and service calls on residential and light commercial wiring projects.

This wall plate is suited for residential and light commercial installations where duplex receptacles are the standard termination point. The oversized profile makes it a practical choice when replacing older or damaged plates that may have left visible wall damage or discoloration around the box opening. The light almond color coordinates with common outlet and switch device colors used throughout standard residential wiring. The 10-pack quantity supports multi-unit installs, apartment turnovers, and service van stocking.

Key Features

• 1-gang configuration with a single duplex outlet opening
• Oversized profile — 3/16 inches taller and wider than standard wall plates for improved coverage
• Molded from self-extinguishing nylon for rugged, long-term durability
• Light almond finish matches common receptacle and device colors
• UL and CSA listed for use in code-compliant electrical installations
• 10-pack quantity reduces per-unit cost on multi-outlet jobs

Compatibility

Designed as an OEM-style replacement or new-installation wall plate for standard 1-gang electrical boxes accepting duplex receptacle configurations.

Installation Notes

Wall plates of this type are installed by licensed electricians or qualified maintenance personnel. Always shut off power at the circuit breaker before servicing any receptacle or device behind the plate. Installation typically requires only a flathead or Phillips screwdriver. Work must comply with applicable NEC requirements for device cover plates and finish work.