Paslode 650231 Angled Finish Nails 1-1/2in 16 Gauge 2000 Count

Product Description

The PASLODE 650231 is a bulk pack of 2,000 angled galvanized finish nails designed for use in pneumatic finish nailers. Each nail measures 1-1/2 inches in length and is manufactured to 16-gauge wire diameter. The galvanized finish provides corrosion resistance suited to interior trim work and protected exterior applications. These nails are collated at an angle for compatibility with magazine-fed nailers. Carpenters and finish trades rely on this format for high-volume trim and molding installation where hand-driving would be impractical.

These finish nails are intended for trim and molding applications, including door and window casing, base molding, crown molding, chair rail, and similar interior millwork. The 1-1/2 inch length provides adequate penetration into framing or substrate without blowthrough on standard trim stock. The galvanized coating makes them suitable for areas with moderate humidity exposure. Each package contains 2,000 nails, supporting extended production runs between reloads.

Key Features

• 1-1/2 inch nail length suited for standard trim and molding stock
• 16-gauge wire diameter for finish-grade holding power with minimal surface damage
• Angled collation for use with angled magazine finish nailers
• Galvanized finish for corrosion resistance in interior and protected applications
• 2,000-count pack reduces reload frequency on high-volume jobs

Compatibility

Specified for use with Paslode Model 500910 and Model 900600 finish nailers.

Installation Notes

Installation should be performed by a qualified carpenter or finish trades professional. Verify nailer air pressure and depth-of-drive settings on scrap material before production work to avoid overdriving or surface damage. Always disconnect the nailer from its power or air source before loading or clearing a jam. Follow all nailer manufacturer safety guidelines and applicable jobsite safety codes.