Parlec C50-10SC7 Collet Chuck CAT50 Tg PG100 Single Angle

Product Description

The PARLEC C50-10SC7 is a single-angle collet chuck designed for precision CNC milling and machining center applications. Built on a CAT50 taper shank, this chuck accepts TG and PG100 series collets and spans a capacity range of 0.0313 to 1 inch, covering the majority of common cutting tool shank sizes. It delivers a total indicator runout (TIR) of 0.0002 inches, supporting tight-tolerance machining operations where tool concentricity is critical. A 7.5-inch projection and through-spindle coolant capability make it well suited for deep-reach cutting and flood or high-pressure coolant systems.

This collet chuck is intended for use on machining centers equipped with CAT50 spindles in industrial manufacturing environments. The 7.5-inch projection allows access to deep pockets and cavities without requiring extended-reach tooling in many cases. Through-spindle coolant delivery directs fluid directly to the cutting zone, improving chip evacuation and tool life in demanding materials. It is sized and configured for production-level setups where repeatable tool holding performance is required across multiple setups.

Key Features

• CAT50 taper shank for compatibility with standard CAT50 spindle interfaces
• Accepts TG and PG100 series single-angle collets
• Collet capacity range: 0.0313 to 1 inch
• TIR of 0.0002 inches for high-precision tool holding
• 7.5-inch projection for extended reach applications
• Through-spindle coolant delivery to cutting zone

Compatibility

Designed for use with CAT50-spindle machining centers and accepts TG series and PG100 series single-angle collets with shank diameters from 0.0313 to 1 inch.

Installation Notes

Installation should be performed by a qualified machinist or tooling technician with the machine powered down and spindle fully stopped. Taper surfaces on both the chuck shank and spindle should be clean and free of chips, oil film, or fretting debris before seating. Drawbar torque should be applied per the machine tool manufacturer specification for CAT50 retention systems. Verify TIR at the collet nose with a dial indicator after installation before commencing any cutting operation.