Parlec C40-10FH5C Single Angle Reamer Collet Chuck CAT40

Product Description

The PARLEC C40-10FH5C is a TG/PG 100 single angle reamer collet chuck designed for precision reaming operations on CNC machining centers. Built on a CAT40 taper shank, this chuck accepts collets ranging from 0.093 inches to 1 inch in capacity and delivers a 5.25-inch projection from the gage line. The through-coolant design directs cutting fluid directly to the tool tip, supporting extended tool life and chip evacuation during reaming cycles. This unit is intended for professional installation and use by machinists and toolroom technicians working in production or job-shop environments.

This collet chuck is suited for CNC vertical and horizontal machining centers running CAT40 spindles. The single angle reamer collet system provides controlled float of 0.015 inches from center, allowing the reamer to self-align with a pre-drilled hole and produce accurate, finished bore diameters. It is commonly used in automotive, aerospace, and general metalworking applications where hole tolerance and surface finish are critical requirements.

Key Features

• CAT40 taper shank for direct mounting in standard CAT40 machining center spindles
• Single angle reamer collet system with 0.015-inch float from center for self-alignment
• Collet capacity range of 0.093 inches to 1 inch accommodates a wide variety of reamer shank sizes
• 5.25-inch projection provides clearance for deep-bore and fixture-heavy setups
• Through-coolant construction delivers cutting fluid directly to the cutting zone

Compatibility

Designed for use with TG/PG 100 series single angle reamer collets on CAT40 taper machining center spindles.

Installation Notes

Installation should be performed by a qualified machinist or toolroom technician. Ensure the machine spindle is fully stopped and the tool changer is in a safe state before mounting or removing the chuck. Clean the CAT40 taper and spindle bore thoroughly before seating to ensure full contact and runout accuracy. Verify drawbar retention force meets machine manufacturer specifications before returning the spindle to service.