Parker WC39R10A Cartridge Filter 1 Micron 10 Inches

Product Description

The PARKER WC39R10A is a string-wound cartridge filter designed for plumbing and water filtration applications. It measures 10 inches in length with a 2.5-inch outside diameter, and it delivers 1-micron particulate filtration. The filter media is acetate cotton wound over a polypropylene plastic core, a construction that provides consistent dirt-holding capacity and stable performance through the full service cycle. This cartridge is rated for water service up to 120 degrees F. It is installed by plumbers and water treatment technicians in residential and light commercial filtration housings.

The WC39R10A is suited for point-of-entry and point-of-use water filtration systems where fine sediment removal is required. Typical applications include whole-house filter housings, pre-filtration ahead of reverse osmosis systems, and inline filtration for foodservice or process water lines. The 1-micron rating captures fine silt, sand, rust particles, and other suspended solids before they reach downstream equipment or fixtures. The 10-inch length fits standard 10-inch filter housings commonly found in residential and light commercial installations.

Key Features

• 1-micron rating for fine sediment and particulate removal
• String-wound acetate cotton media for high dirt-holding capacity
• Polypropylene plastic core for structural integrity during service
• 2.5-inch outside diameter fits standard 10-inch filter housings
• Rated to 120 degrees F maximum working temperature
• Weighs 2.95 pounds; no tools required for cartridge changeout

Compatibility

Designed as an OEM-style replacement cartridge for standard 10-inch plumbing filter housings that accept a 2.5-inch outside diameter string-wound cartridge.

Installation Notes

Installation is performed by a licensed plumber or qualified water treatment technician. Shut off the water supply and relieve system pressure before opening the filter housing. Inspect the housing O-ring and replace it if worn before re-seating the housing. Follow local plumbing codes, including IPC requirements, for any permanent connections upstream or downstream of the filter assembly.