Parker W171PLP-8M-2R Swivel Male Run Tee 8mm 300 Psi

Product Description

The PARKER W171PLP-8M-2R is a push-to-connect swivel male run tee fitting designed for tube-to-tube-to-male connections in pneumatic and fluid systems. Constructed from nickel-plated brass, it accepts 8mm outside diameter tubing on the tube ports and terminates with a 1/8 inch BSPT male thread on the branch. The fitting is rated to 300 psi maximum working pressure and operates across a temperature range of 0 to 200 degrees F. The yellow release button allows quick, tool-free tube removal during service or reconfiguration. This fitting is silicone-free and meets the UL94 V-0 flame resistance standard, making it suitable for installations where ignition resistance is required.

This fitting is used in compressed air lines, pneumatic control circuits, and fluid distribution systems in commercial and industrial environments. The swivel male run configuration allows the branch port to rotate for alignment during installation, reducing stress on adjacent tubing and connections. HVAC technicians, industrial maintenance professionals, and pneumatic system integrators commonly install this type of fitting when routing 8mm tubing runs that require a teed branch with a threaded male takeoff. Its compact profile suits tight panel or cabinet installations.

Key Features

• Push-to-connect tube ports accept 8mm outside diameter tubing without tools
• Swivel male branch port simplifies thread-in alignment during installation
• Nickel-plated brass construction provides corrosion resistance
• 300 psi maximum working pressure rating
• Rated for use from 0 to 200 degrees F
• Silicone-free grease and UL94 V-0 flame resistance compliance

Compatibility

Designed for use with 8mm outside diameter tubing on push-to-connect ports and 1/8 inch BSPT male threaded connections in pneumatic and fluid systems rated up to 300 psi.

Installation Notes

Installation is performed by qualified pneumatic or fluid system technicians. Depressurize and isolate the system fully before removing or installing any fittings. Insert tubing straight and fully into the push-to-connect ports until seated; to release, depress the yellow collar and pull the tube straight out. Verify that the BSPT thread type is compatible with the receiving port before installation, as BSPT is a parallel thread standard and differs from NPT taper threads.