Parker VS272NTA-8-8 Compression Male Branch Tee 1/2 in

Product Description

The PARKER VS272NTA-8-8 is a brass compression tube male branch tee designed for use in fluid and pneumatic distribution lines where a branch connection is required. The fitting provides three connection points: two compression ends and one male NPT (MNPT) port, allowing a branch takeoff from a continuous tube run. Rated to 150 psi maximum working pressure and suitable for temperatures from -40 degrees F to 200 degrees F, this fitting is built to handle demanding service conditions. The brass body resists corrosion and is compatible with a wide range of fluids common in HVAC, refrigeration, and plumbing systems. Licensed plumbers, HVAC technicians, and mechanical contractors are the primary installers.

This fitting is used in residential and light commercial applications where a 1/2 inch OD tube line requires a branch connection to a male NPT port. Typical install scenarios include refrigeration piping, compressed air distribution, and water service lines. The NPTF thread standard ensures a pressure-tight seal on the male NPT end without relying solely on thread sealant. Sold individually, it suits service calls and small-volume installations alike.

Key Features

• Compression x Compression x MNPT end connections for tool-free tube installation on both run ends
• NPTF thread standard on the male NPT port for a reliable pressure-tight fit
• Rated to 150 psi maximum working pressure
• Temperature range from -40 degrees F to 200 degrees F
• Brass construction for corrosion resistance across a broad range of media
• 1/2 inch tube outside diameter compatibility on both compression ends

Compatibility

Designed as an OEM-style branch tee fitting for 1/2 inch OD compression tube lines terminating to a male NPT port in HVAC, refrigeration, plumbing, and compressed air systems.

Installation Notes

Installation should be performed by a licensed plumber, HVAC technician, or qualified mechanical contractor in accordance with applicable codes including the IPC and IFGC. Depressurize and drain or evacuate the system fully before disassembling any existing fittings or inserting this tee. Ensure tube ends are cut cleanly and deburred before seating into the compression fittings; a proper ferrule seat is critical to holding rated pressure. Apply an appropriate thread sealant or PTFE tape to the MNPT end per local code requirements before making up the connection.