Parker T23R10A String-wound Cartridge Filter 5 Micron

Product Description

The PARKER T23R10A is a string-wound polypropylene cotton cartridge filter designed for plumbing filtration applications. Measuring 10 inches long with a 2.5-inch outside diameter, this filter delivers 5-micron particulate removal to protect downstream equipment and maintain water quality. The string-wound construction creates a graded density matrix that captures sediment, dirt, rust, and scale throughout the full depth of the media, not just on the surface. A polypropylene plastic core provides structural support under flow and pressure conditions. This filter is suited for residential and light commercial plumbing systems and is typically installed by licensed plumbers or qualified service technicians.

This cartridge is used in standard whole-house or point-of-entry filtration systems, as well as irrigation pre-filtration and general water treatment applications where sediment reduction at 5 microns is required. The 10-inch length fits a wide range of standard industry housings commonly found in plumbing supply and water treatment installations. The non-FDA material grade makes this cartridge appropriate for non-potable or general service water systems rather than direct food-contact or drinking water applications.

Key Features

• 5-micron rating captures fine sediment, rust, and particulate throughout the filter depth
• String-wound construction provides graded density filtration for extended service life
• Polypropylene cotton media with polypropylene plastic core resists moisture and common chemicals
• 10-inch length fits standard cartridge filter housings
• 2.5-inch outside diameter for compatibility with common residential and light commercial housings
• Rated to a maximum working temperature of 120 degrees F

Compatibility

Designed as an OEM-style replacement or service cartridge for standard 10-inch string-wound sediment filter housings used in residential and light commercial plumbing filtration systems.

Installation Notes

Installation is typically performed by a licensed plumber. Shut off the water supply and relieve system pressure before opening the filter housing. Inspect the housing o-ring and replace it if worn before reinstalling the cap. This cartridge is rated for non-FDA service only and should not be used in potable drinking water applications without confirming system suitability.