Parker PC316V-BP 90 Deg Push-lok Hose Barb Coupler 3/8 in

Product Description

The PARKER PC316V-BP is a 90-degree Push-Lok hose barb coupler designed for fluid transfer applications requiring a secure, tool-free hose connection. Built from brass, this valved fitting accepts 3/8-inch hose diameter and is rated to 200 psi working pressure. The valved design allows the line to be disconnected without full system depressurization, making it a practical choice for maintenance-intensive installations. It carries a temperature range of -20 degrees F to 400 degrees F, supporting use across a wide range of hydraulic and pneumatic service conditions. Licensed plumbing and hydraulic technicians install this type of fitting in both stationary and mobile fluid power systems.

The PC316V-BP is suited for residential and light commercial fluid systems where a 90-degree hose routing change is needed at the connection point. Its non-threaded, Push-Lok barb design allows the hose to be pushed directly onto the barb and secured without clamps or threading tools, simplifying installation in tight spaces. The Moldmate series designation indicates a standardized form factor consistent with Parker line fittings used in hydraulic hose assemblies. This fitting is appropriate for applications where hose routing must change direction at the coupling point.

Key Features

• 90-degree Push-Lok hose barb configuration for directional hose routing at the connection point
• Valved design allows disconnect without full system depressurization
• Brass construction provides corrosion resistance in fluid transfer environments
• 200 psi pressure rating suitable for low-to-medium pressure hydraulic and pneumatic lines
• Wide service temperature range: -20 degrees F to 400 degrees F
• Non-threaded barb end accepts 3/8-inch hose with no clamps or thread sealant required

Compatibility

Designed as an OEM-style replacement or new-installation fitting for 3/8-inch Push-Lok hose assemblies within the Parker Moldmate series product line.

Installation Notes

This fitting is typically installed by licensed hydraulic technicians or plumbers working on low-to-medium pressure fluid systems. Before disconnecting or replacing any fitting, relieve system pressure fully and follow applicable lockout/tagout procedures. Push the hose firmly onto the barb until it seats against the fitting body stop. Inspect the connection for leaks before returning the system to full operating pressure.