Parker DBC25M10 Cartridge Filter 25 Micron 2.5 in Od

Product Description

The PARKER DBC25M10 is a thermal-bonded polyolefin cartridge filter designed for plumbing filtration applications. It measures 10 inches in length with a 2.5-inch outside diameter and delivers filtration down to 25 microns. The polyolefin construction meets FDA material grade standards, making it suitable for potable water and food-adjacent service lines. Licensed plumbers and water treatment technicians install this filter in standard cartridge filter housings to remove sediment, particulate, and suspended solids from supply lines in residential and light commercial systems.

This cartridge is suited for residential and light commercial plumbing systems where sediment control is required upstream of fixtures, appliances, or water treatment equipment. The 25-micron rating targets coarser particulate such as sand, rust scale, and pipe debris. Its polyolefin media and FDA-grade material classification make it appropriate for installations on potable water lines. Maximum working temperature is rated to 175 degrees F, supporting both cold and hot water line service.

Key Features

• 25-micron filtration rating captures sediment, rust, and coarse particulate
• Thermal-bonded polyolefin construction resists media migration
• FDA material grade rating suitable for potable water applications
• Rated to 175 degrees F maximum working temperature
• Standard 2.5-inch OD and 10-inch length fits common cartridge housings

Compatibility

Designed as a direct-fit replacement for standard 10-inch cartridge filter housings accepting a 2.5-inch outside diameter cartridge in residential and light commercial plumbing systems.

Installation Notes

Shut off the water supply and relieve line pressure before opening the filter housing. A licensed plumber should perform installation on potable water systems per applicable local plumbing codes. Inspect housing o-ring condition before reinstalling the cap, and verify the cartridge seats fully before restoring pressure. Do not exceed the rated maximum working temperature or pressure for the housing in use.