Parker DBC10M30 Cartridge Filter 10 Micron 30 in

Product Description

The PARKER DBC10M30 is a thermal bonded polyolefin cartridge filter designed for plumbing and fluid filtration applications. It measures 30 inches in length with a 2.5-inch outside diameter and delivers 10-micron filtration to capture sediment, particulates, and suspended solids from water lines. The polyolefin construction meets FDA material grade standards, making it suitable for potable water systems. Licensed plumbers and water treatment technicians install this filter in standard filter housings as part of whole-building or point-of-entry filtration setups. Maximum working temperature is 175 degrees F.

This cartridge is suited for residential and light commercial plumbing systems where consistent sediment reduction is required upstream of softeners, RO units, appliances, or process equipment. The 10-micron rating handles moderate particulate loads from well water, municipal supplies, and recirculating systems. Its 30-inch length fits high-capacity filter housings common in commercial-grade point-of-entry installations. The FDA-grade polyolefin material is appropriate for use in drinking water and food-service adjacent plumbing lines.

Key Features

• Thermal bonded polyolefin construction — no fiber migration into the water stream
• 10-micron nominal filtration rating for sediment and particulate removal
• FDA-grade material suitable for potable water applications
• Rated to 175 degrees F maximum working temperature
• 30-inch length fits high-capacity commercial filter housings
• 2.5-inch outside diameter for compatibility with standard large-format filter sumps

Compatibility

Designed as an OEM-style replacement cartridge for standard large-format plumbing filter housings accepting a 2.5-inch OD, 30-inch cartridge.

Installation Notes

Installation should be performed by a licensed plumber in accordance with applicable IPC and local plumbing codes. Shut off the water supply and relieve system pressure before removing the filter housing. Inspect the housing o-ring for wear and replace if needed before installing the new cartridge. Do not exceed the rated maximum working temperature of 175 degrees F in the installed system.