Parker DBC10M10 Cartridge Filter 10 Micron Polyolefin

Product Description

The PARKER DBC10M10 is a thermal-bonded polyolefin cartridge filter designed for plumbing and water filtration applications. Rated at 10 microns, it captures sediment, rust, and particulate matter from water lines before they reach downstream fixtures, equipment, or appliances. The filter measures 2.5 inches in outside diameter and 10 inches in length, fitting standard 10-inch filter housings. Constructed from FDA-grade polyolefin, it is suitable for potable water systems and rated for service up to 175 degrees F. Licensed plumbers and water treatment technicians are the typical installers for this type of filter cartridge.

This cartridge filter is suited for residential and light commercial plumbing systems where sediment filtration is required at point-of-entry or point-of-use locations. Typical applications include whole-house sediment pre-filtration, inline protection for water heaters, boilers, and ice makers, and pre-filtration ahead of reverse osmosis or other treatment systems. Its thermal-bonded construction provides consistent 10-micron filtration throughout the depth of the media without the use of binders or adhesives.

Key Features

• 10-micron rating removes sediment, rust, and fine particulate from water supply lines
• Thermal-bonded polyolefin construction eliminates binders that could leach into the water stream
• FDA-grade material makes it suitable for potable water and food-service applications
• Rated for maximum working temperatures up to 175 degrees F
• Standard 10-inch length and 2.5-inch OD fits widely available filter housings
• Lightweight at 0.5 pounds for easy handling and cartridge changeout

Compatibility

Designed as an OEM-style replacement cartridge for standard 10-inch plumbing filter housings accepting a 2.5-inch outside diameter cartridge. Verify housing inlet and outlet sizing before installation.

Installation Notes

Installation should be performed by a licensed plumber in accordance with local plumbing codes and IPC guidelines. Shut off the water supply and relieve system pressure before opening the filter housing. Inspect the housing O-ring for wear and replace if needed before seating the new cartridge. Do not exceed the rated maximum working temperature of 175 degrees F for this cartridge.